- Title: BestRom+Mod Bonus Clockworkmod Full Sysytem+20130423 e2001 v89 gq2008s
- Listed: 07/05/2015 1:53 pm
- ROM Version: 4.2.1
You must be logged for ROM download.
2358 total views, 1 today
536 Total downloads
Excuse me for the translation. translated by Google
Create a new folder on PC, such as N9589. Track to do it as short as possible (to avoid confusion). The folder names are not unusual and should be a symbol of Chinese (and Russian is better to avoid).
Create a subfolder called firmware, for example: STAR-N9589-20130423_e2001_v89_gq2008s and firmware to unpack.
Next, create a folder firmware example SP_Flash_Tool_v3.1304.0.119 and unpack the files there firmware.
All installation of drivers and firmware to do better with the extracted battery !!
The fact that the broaching modem is powered purely by USB, background battery voltage causes spiking and flasher afraid low voltage. In addition, it accelerates the firmware after repeated failures, as Android with the battery removed is not loaded.
Install USB drivers firmware
MT6577 USB VCOM drivers
Check the correct installation. Go to the section Ports Device Manager.
Connect your smartphone to USB.
On the serviceable and stitched Device, a couple of seconds after the port will be: Preloader USB VCOM.
If divays blank or spoiled preloader, you will see a simple COM port xx.
Turning off the phone from the PC.
If everything is OK, proceed to the firmware.
Run SP Flash Tool. In the Scatter loading File point to the firmware file MT6589_Android_scatter_emmc.txt.
As long as you do not experience the firmware, it is better to remove the check mark from section Preloader. This bootloader firmware, unless the new firmware incompatible Preloader, you can bake expensive brick. If your smartphone is defined as a simple COM xx, it has nowhere to go and sew followed with preloader. In this case, sew better in Upgrade.
Firmware begins by pressing the DownLoad. Putting Options-Do Download All – Speed -Do Not swicth down
It should be borne in mind that broaching the modem if no references to it, is active only a few seconds after connecting the USB. Therefore, you must first press the DownLoad, and then to connect the USB cord.
We wait until the end of the firmware, watching the progress bar at the bottom of firmware. Firmware lasts 5 minutes when a window pops up with a banner OK, the firmware is complete.
Insert the battery, turn device.
If you do not go through the Download, you can try through the Upgrade. Do not go – to play Substation
If you do not go through the Download, you can try through the Upgrade. Do not go – to play the check mark from section DA DL All With Checksumt
1. Perform first archive 1
2. Then archive 2
If you want to keep the original firmware, then from the archive 2 does not sew clockworkmod
if you change your mind go further. The archive 2 -”recowery630″ rename to “recovery”.
3. Follow the archive 3
-TWRP + Recovery + 22.214.171.124 is a full touchscreen recovery
-recowery630 -before firmware renamed to recowery, normal recowery (not the sensor!) only works with the old backup
in “clockworkmod” it has already “Root manager”,and so “recovery_supersu2.47″ manager so you can not install
When you first boot files of settings through customizable status bar, select the type of batteries battery, Statusbarmods customizable transparency and color of curtains and status bar status bar, then the transparency can be adjusted in most settings, turn the clock if needed. The setup / screen FloatService added on later firmware, plus adjustment Backlight lower buttons, I do them because I switch off use the screen, who do not need these buttons via the Route Explorer file build.prop in line ro.show.navigationbar = yes put no. The settings / Sound Profiles / General, you can set a different ringtone for the SIM card, just in settings / sound profiles added dspmanager, ringdroid (installation included tunes and SMS to different SIM cards), and the program from flip mute (on michfud), the program sms black tones, contacts in the black tones, well, not talking about transparency, in the dialer activated the black list (Settings / Calls / Other Settings / Blacklist), Calendars taken from another firmware, watch, too, in the widget has a lock that puts the screen. Pop-up windows in the style of an Angel. Extended menu off. Operator logos, can generally still that …
Due to the limited and I have nowhere else to lay smashed on the archives. Unpack the memory card backup made after full reseta, so no extra or anything, I think you can do a full restore. Backup did Carliv CWM 126.96.36.199 (it will also be the default full flash), the core of July 15, of July 09, the radio module.
※Please make a backup of your device before installing or updating ROM