• Title: Galaxy S2 T989
  • Listed: 04/09/2013 6:44 pm
  • ROM Version: ROM Android 4.1.2
  • You must be logged for ROM download.



0 votes, average: 0.00 out of 50 votes, average: 0.00 out of 50 votes, average: 0.00 out of 50 votes, average: 0.00 out of 50 votes, average: 0.00 out of 5 0

2858 total views, 1 today


  



Galaxy S2 T989

Author adMember Info

SoCr@Te

  • Listed by: SoCr@Te
  • Member Since: 05/15/0470

DESCRIPTION


ROM Galaxy S2 T989 – ROM Android 4.1.2

ROM Official Samsung : T989UVMC6_T989TMBMC6_TMB

 

Install ROM:

1.Extract Firmware zip file that you downloaded already from above link, you will get a .tar.md5 file and some other files.

2.Extract Odin zip file and you will get Odin3 v3.07.exe along with few other files.

3.Power off your phone. Wait 5-6 seconds for vibration to confirm complete switch off.

4.Now, put the Galaxy S2 T989 phone in Download Mode by pressing and holding down the Volume Down and Volume Up keys. Keep the buttons pressed and connect your phone to the computer via USB cable. Wait until Download Mode boots.

5.Now run Odin3 v3.07.exe (see Step 2) as an Administrator because Admin privileges is required to complete the process smoothly.

6.A message will arrive under Odin’s message box in the bottom left saying “Added!!”. If you don’t get the same then you should try another USB port (try USB port located in back in your desktop PC). If that too don’t work then you should then reinstall the driver. If you successfully see the “Added!!” message in Odin then you are ready to go in next step. You should also see COM port with a number in Yellow if you successfully added your device.

7.Select these files in Odin at respective buttons from extracted T989UVMC6 firmware folder : 1.Click the PDA Button, and select the .tar file here with *code* appearing in its name

2.Click the Phone Button, and select file with *modem* in its name (leave it blank if there is no such file)

3.Click the CSC Button, and select file with *csc* in its name (leave it blank if there is no such file)

4.Click the PIT Button, and select the .pit file. Use only if you got it while extracting in step 1 above, otherwise ignore it.

8.In Odin window, make sure Auto Reboot and F. Reset Time checkboxes are selected. Also, make sure that Re-Partition checkbox is selected, only if you are using a .pit file (see Step 7.4).

9.Double check everything that we mentioned in Step 7 & Step 8 above. Now, once satisfied hit the START button to begin the flashing process.

10.Once flashing completed, your phone will restart and soon you will see a PASS message with green background in the left-most box at the very top of the Odin. You can now unplug the USB cable to disconnect your device from computer.

Share Button

No Tags

Leave a Reply

You must be logged in to post a comment.

banner