• Title: Recovery TWRP
  • Listed: 07/30/2017 6:38 pm
  • ROM Version: 3.0.2
  • You must be logged for ROM download.

Overall Rating : 2

950 total views, 3 today

4 Total favorites

142 Total downloads


Recovery TWRP

Author adMember Info


Recovery TWRP 3.0.2 by jemmini (4PDA) for Cubot Echo.

Download and unzip the archive.
Check that the USB Preloader driver are installed and use a recent version of Flashtrool.
The device should be switched off and disconnected by PC.
Remove the Battery.
Run Flashtool, select the scatter, check that only Recovery partition is flagged, then select DOWNLOAD.
Only now Connect the device (switched off and without the battery) to the PC with a short USB cable directly connecetd to USB PC port.
Wait the end of Flashtool process (green tick).
After that you can disconnect the device from PC.

To test the recovery press in the device POWER and VOLUME+ to start in recovery mode.
Please don't enable in recovery mode the system as writable (make a bootloop)
To restart from recovery in normal mode select REBOOT SYSTEM.

Share Button

※Please make a backup of your device before installing or updating ROM

11 Responses to“Recovery TWRP”

  1. 01/23/2017
    Posts: 39


    is safe to install twrp 3.0.2 with android 6.0 does this recovery work

  2. 03/31/2017
    Posts: 3

    South Africa

    Rooted my Cubot Echo (Android 6.0) using this TWRP, SPflash  and SuperSU v2.82. I dont know if this will help anyone or whether I am just stating the obvious, I am new to this. Never again with cheap Chinese phones!

  3. 03/31/2017
    Posts: 3

    South Africa

    Kernal version 3.18.19

    Build Number CUBOT_ECHO_6061C_v13_20161115

    Hope it helps. I couldnt use the phone with the pre-installed malware so, I didnt think I had anything to lose trying it. I have now got rid of Adups.Fota and the adware. Malwarebytes now says it is clean.

  4. 03/31/2017
    Posts: 3

    South Africa

    I know Adups.Fota is for firmware updates but, I certainly  dont want any of Cubots Firmware updates anyway

  5. 01/23/2017
    Posts: 39

    here is twrp 3.1.1 ported and tested and all working .

  6. 01/23/2017
    Posts: 39


    this site is in russian language got roms for cubot echo ,but you need to translate .


  7. 01/23/2017
    Posts: 39


    need more development in this phone ,more costum roms .

  8. 10/14/2017
    Posts: 1

    United States


    I tried to install twrp with what is on this platform but am not able. 

    When I issue fastboot boot recovey.img in command prompt I get this error message 

    FAILED (remote: invalid kernel address: not lie in memory)

    after I have successfully run fastboot flash recovery recovery.img

    Please can you help me.

  9. 10/20/2017
    Posts: 1


    I couldn't get MTK Droid Tools to work with Echo and so couldn't get scatter file and backup with SP Flash tool.

    Decided to use yolo route and flash this recovery without any backups.

    Fortunately it's working as intended and finally made backup with TWRP.

    Thanks for this release.

Leave a Reply

You must be logged in to post a comment.